How to Remove an Xbox 360 Faceplate (Original "Fat" Model)

Applies to original Xbox 360 (2005-2010). Xbox 360 S/E have non-removable shells.

Tools

• #1 or #2 Phillips screwdriver (magnetic tip recommended).
• Plastic pry tool / old credit card / guitar pick (optional, prevents scratches).
• Soft cloth / microfiber.

Steps

1. Power Off & Unplug: Remove power brick from wall AND console. Wait 30 sec (capacitor discharge).
2. Remove Hard Drive: Press release button on side, lift off. (If present).
3. Locate 4 Screws: Bottom of console, under the four rubber feet. Peel feet back gently (they re-stick).
4. Unscrew: Remove all 4 screws. Keep them safe (magnetic tray).
5. Release Faceplate: Stand console upright. Insert pry tool at bottom center seam (between faceplate and chassis). Gently twist to pop clips. Work left→right along bottom edge.
6. Lift Off: Faceplate hinges at top. Lift bottom edge up and away. Top tabs will release.

Reinstall

1. Align top tabs first. Hook them in.
2. Press bottom edge down firmly until clips snap (audible clicks).
3. Replace 4 screws. Re-apply rubber feet. Reattach HDD. Reconnect power.

Safety

• Never touch the metal RF shielding or motherboard.
• Do not force clips; they are brittle plastic. Warm with hairdryer (low) if stiff.
• Custom faceplates (eBay, 3D printed) install identically.