Programming a Mad Catz PS3 Controller: Remap, Sensitivity & Macros

"Programming" a Mad Catz PS3 controller typically means remapping buttons, adjusting stick sensitivity or dead zones, and recording macros. However, support for these features varies significantly by model.

Common Mad Catz PS3 Models & Their Capabilities

On-Board Remapping (F.L.Y. 9 / M.L.G. Pro)

These controllers let you remap buttons directly on the hardware:

1. Hold the PROG button (on the back) for ~3 seconds until the LED blinks.
2. Press the source button you want to copy (e.g., R1).
3. Press the target button you want it to become (e.g., L1).
4. Repeat steps 2–3 for each remap.
5. Hold PROG for 3 seconds again to save and exit.

System-Level Remapping (All PS3 Controllers)

The PS3 itself offers a universal button-swap feature that works in every game:

1. Go to Settings → Accessory Settings → Controller 1 → Button Assignment.
2. Select any two buttons to swap. This remap applies system-wide.

Adjusting Sensitivity & Deadzone

• Global: Settings → Accessory Settings → Controller Sensitivity.
• Per-game: Most shooters and action titles have their own Look Sensitivity and Deadzone sliders under Options → Controls.

Macro Support

Macros are only possible on PC-supported models like the R.A.T. mouse or S.T.R.I.K.E. keyboards via the discontinued Mad Catz software (available from archives). The PS3 firmware blocks macro injection entirely.

Important Cautions

• Third-party remap tools or XInput wrappers on PC can brick controller firmware.
• Using macros in online games carries a high ban risk.